RIDGID SS1650 1 Manual del operador descargar pdf (Pagina 9)

ASSEMBLY

Fig. 11

NOTE: The minimum height of the leg stand is 24 in.

and the maximum is 34 in.. The distance between holes

in the lower leg(s) is approximately 2-1/2 in. The actual

height setting will depend on the type of tool and the

operator’s preference.

n Place a carriage bolt through only the bottom hole of the

upper leg and then through the desired hole in the lower

leg. Finger tighten nut.

Fig. 12

ASSEMBLING LOWER BRACES

See Figures 13-16.

n Locate the following parts and hardware.

Carriage Bolts, M8 x 1.25-16 (16)

Hex Flanged Nuts, M8 x 1.25 (16)

Lower Left Braces, (Stamped “CL”) (4)

Lower Right Braces, (Stamped “CR”) (4)

NOTE: Hardware not pictured full size.

n Position the lower left brace stamped “CL” on the inside

of the left leg assembly and secure with carriage bolt

and nut as shown. Finger tighten only.

n Position the lower right brace stamped “CR” on the

inside of the right leg assembly and secure with carriage

bolt and nut as shown. Finger tighten only

Fig. 13

n Position the lower left brace stamped “CL” inside the

lower right brace stamped “CR” for the desired width

setting.

Fig. 14

n Place two carriage bolts through the assembly and

finger tighten each nut.

Fig. 15

UPPER

LEG

LOWER LEG

WITH LEVELING

FOOT

LOWER LEFT

BRACE

LOWER RIGHT

BRACE

NUT

CARRIAGE

BOLT

LOWER LEFT

BRACE

NUT

CARRIAGE

BOLT

LOWER RIGHT

BRACE

1 2 3 4 5 6 7 8 9 10 11 12 13

Comentarios a estos manuales

Sin comentarios

RIDGID SS1650 1 Manual del operador Pagina 9

Comentarios a estos manuales

Relacionado con productos y manuales para Sierras circulares RIDGID SS1650 1