RIDGID TS3650 Manual del operador descargar pdf (Pagina 30)

OPERATION

Fig. 41

Fig. 42

Fig. 43

PUSH BLOCKS

PUSH STICKS

CUTTING AIDS

See Figure 41.

Push sticks are devices used for safely pushing a workpiece

through the blade. They can be made in various sizes and

shapes from scrap wood to use in a specific project. The

stick must be narrower than the workpiece, with a 90˚ notch

in one end and shaping for a grip on the other end.

A push block has a handle fastened by recessed screws

from the underside. Be sure the screw is recessed. Use it

on non-through cuts.

AUXILIARY FENCE

An auxiliary fence is a device used to close the gap between

the rip fence and the saw table. Always make and use an

auxiliary fence when ripping material 1/8 in. or thinner.

HOW TO MAKE AND ATTACH AN AUXILIARY

FENCE (FOR RIP CUTTING THIN

WORKPIECE)

See Figure 42.

An auxiliary fence may be made for the saw by cutting a

piece of wood to 3/4 in. thick, 3-1/2 in. wide, and 31 in. long.

To attach the auxiliary fence to the rip fence:

 Drill two countersunk holes in the locations shown.

WARNING:

When mounting an auxiliary fence face, position

mounting hardware beyond arrows at right and

left. Keep fasteners away from blade.

 Slide two T-bolts (not included) into the rip fence groove

beyond the arrows at right and left of the label on the rip

fence.

 Match the T-bolts to the holes in the auxiliary fence and

secure it to the rip fence with a washer and nut.

 Ensure that the auxiliary fence is securely attached before

use.

HOW TO MAKE A JIG (FOR RIP CUTTING

NARROW WORKPIECE)

See Figure 43.

If ripping a narrow workpiece places the hands too close to

the blade, it will be necessary to make and use a jig.

To make a jig:

  Attach a handle to a long, straight piece of wood and

secure from the underside using recessed screws.

  Cut an L-shaped stop in the side of the jig.

To use a jig:

  Position the workpiece flat on the table with the edge

flush against the jig and against the stop.

  Holding the jig handle and using a push block, make the

rip cut as described later in this section.

JIG

HANDLE

STOP

RIP

FENCE

AUXILIARY

FENCE

T-BOLT

3/4 in.

3-1/2 in.

31 in.

WASHERNUT

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 53 54

Comentarios a estos manuales

Sin comentarios

RIDGID TS3650 Manual del operador Pagina 30

Comentarios a estos manuales

Relacionado con productos y manuales para Sierras circulares RIDGID TS3650