RIDGID MS 1290 Guía para resolver problemas Pagina 10
- Pagina / 56
- Tabla de contenidos
- SOLUCIÓN DE PROBLEMAS
- MARCADORES
Valorado. / 5. Basado en revisión del cliente
10
Motor Specifications and Electrical Requirements (continued)
Polarized Plug
Your unit has a plug that looks like the one
shown on next page.
To reduce the risk of electrical shock, this
appliance has a polarized plug (one blade
is wider than the other). This plug will fit in
a polarized outlet only one way, if the plug
does not fit fully in the outlet, reverse plug.
If it still does not fit, contact a qualified
electrician to install the proper outlet. Do
not change the plug in any way.
WARNING: Double insulation
does not take the place of normal
safety precautions when operat-
ing this tool.
Motor Safety Protection
1. Connect this tool to a 120v, 15-amp
branch circuit with a 15-amp time delay
fuse or circuit breaker. Using the wrong
size fuse can damage the motor.
2. If the motor won't start, release the trig-
ger switch immediately. Unplug The
Tool. Check the saw blade to make
sure it turns freely. If the blade is free,
try to start the motor again. If the motor
still does not start, refer to the "Motor
Troubleshooting Chart."
3. If the motor suddenly stalls while cut-
ting wood, release the trigger switch,
unplug the tool, and free the blade from
the wood. The motor may now be
restarted and the cut finished.
4. Fuses may "blow" or circuit breakers
may trip frequently if:
a. Motor Is Overloaded-Overloading
can occur if you cut too rapidly or
make too many start/stops in a short
time.
b. Line voltages are more than 10%
above or below the nameplate volt-
age. For heavy loads, however, the
voltage at motor terminals must equal
the voltage specified on nameplate.
c. Improper or dull saw blades are used.
5. Most motor troubles may be traced to
loose or incorrect connections, over-
load, low voltage (such as small size
wire in the supply circuit) or to overly
long supply circuit wire. Always check
the connections, the load and the sup-
ply circuit whenever motor doesn't work
well. Check wire sizes and length with
the Wire Size Chart below.
Wire Sizes
NOTE: Make sure the proper extension
cord is used and is in good condition. The
use of any extension cord will cause
some loss of power. To keep this to a min-
imum and to prevent overheating and
motor burn-out, use the table below to
determine the minimum wire size (A.W.G.)
extension cord.
For circuits that are farther than 100 feet
away from electrical service box, the wire
size must be increased proportionately in
order to deliver ample voltage to the saw
motor.
Extension Cord
Length
Wire Sizes
Required for 120V
(A.W.G.)
110-120V
0-25 Ft.
26-50 Ft.
14
12
- Table of Contents 2
- Safety Signal Words 3
- Before Using The Saw 3
- Before Each Use 4
- Preparing to Make Cut 6
- Before Leaving The Saw 8
- Assembly 13
- Assembly (continued) 14
- Four Basic Saw Controls 15
- Alignment (Adjustments) 17
- (Miter Alignment) 18
- Miter Lock Lever Adjustment 20
- Bevel Lock Lever Adjustment 21
- Mounting The Miter Saw 22
- Dress For Safety 24
- Preparing to Make the Cut 25
- Whenever Saw Is Running 26
- Before Leaving The Saw: 26
- Basic Saw Operations 27
- Chop Cutting 28
- Body and Hand Position 28
- Miter Cut 29
- Miter Scale Usage 29
- Bevel Cut 29
- Sliding Fence 29
- Cutting Bowed Material 30
- WARNING: Avoid thrown 31
- Workpiece Support 32
- Auxiliary Fence 32
- Rough Cutting A Dado 33
- Cutting Base Moldings 33
- Cutting Crown Moldings 34
- Support Jig 35
- degrees 36
- Maintenance and Lubrication 38
- Lubrication 39
- Motor Belt Tension 39
- Accessories 40
- Using Carbide Tipped Blades 40
- Troubleshooting Guide 41
- Wiring Diagram 42
- Repair Parts 44
- CALL 1-800-4-RIDGID 56
Relacionado con productos y manuales para Tronzadoras RIDGID MS 1290
Tronzadoras RIDGID MS1250LZ1 Manual del operador
(34 paginas)
(34 paginas)
Tronzadoras RIDGID AC9944 Manual del operador
(38 paginas)
(38 paginas)
Tronzadoras RIDGID MS255SR Manual de uso y cuidado
(36 paginas)
(36 paginas)
Philips FWM75/22 manuels
Manuels d'utilisation et guides de l'utilisateur pour Non Philips FWM75/22.
Nous fournissons des manuels en pdf 3 Philips FWM75/22 à télécharger gratuitement par type de document : Manuel de l'utilisateur
Comentarios a estos manuales